stainless steel designer jewelry wholesale Pendant rope editing method

jewelry los angeles wholesale The tools that need to be prepared are: to play well -perforated jewelry pendants (natural crystals, gems, jade), ropes of pendant, a scissors, and a lighter.
1. Use the two ends of the fine rope for punching on the suspension with the pre -prepared lighter, and quickly twist it into a fine silk (see the picture here, pay attention to prevent the hand scald), and then use scissors to use scissors to put the rope with scissors. Cut off the irregular part of the end;
2. Pass the sling through the front part of the pendant (see the picture), and then keep the pendant hole and the top of the suspender rope at a distance of about 1cm (the length can be reserved according to your actual needs) ;
3, the pendant faces up, separate the sling rope, tie the rope No. 1 and No. 2 rope, and tighten the ends of the rope gently, as shown in the small picture in the lower left corner; Turn the pendant over, face up, press the third step, tighten the rope gently, as shown in the small picture in the lower right corner of the figure;
5, the pendant faces the front Kids;
6. Repeat the above steps three times to get the appearance of the pendant knot method shown in Figure 6. At this point, you can choose not to continue to knot.
7. After the pendant is knotted, the excess rope head should be cut quickly with scissors to ensure that it is neat after cutting. Mainly do not cut too much or too little (reserved about 1-2mm);
8, then burn the rope port with a lighter, and press the rope port.
9. At this point, this pendant rope compilation is completed.